Engaging selector lever
To prevent the vehicle from creeping after you
select a drive mode, maintain pressure on the
brake pedal until you are ready to start.
Only when the drive-ready state is switched on
and the brake pedal is depressed is it possible to
change from selector lever position P to another
selector lever position.
The selection lever position P cannot be
changed until all technical requirements are met.
Engaging selector lever position D,
A selector lever lock prevents the following faulty
▷ Unintentional shifting into selector lever posi‐
▷ Unintentional shifting from selector lever po‐
sition P into another selector lever position.
1. Fasten driver's safety belt.
2. Press and hold the button to release the se‐
lector lever lock.
3. Push the selector lever in the desired direc‐
tion, past a resistance point, if needed. The
selector lever automatically returns to the
center position when released.
Engaging selector lever position P
Press button P.
Rolling or pushing the vehicle
In some situations, the vehicle is to roll without
its own power for a short distance, for instance in
a vehicle wash, or be pushed.
Engaging selector lever position N
Switch on drive-ready state while pressing on
the brake pedal.
2. If necessary, release the parking brake.
3. If necessary, switch off Automatic Hold, refer
to page 125.
4. Depress the brake pedal.
5. Touch the selector lever lock and engage se‐
lector lever position N.
6. Switch off drive-ready state.
Online Edition for Part no. 01402896703 - X/18