Switching on drive-ready state via
emergency detection of the BMW
It is not possible to switch on the drive-ready
state if the display key has not been detected.
Proceed as follows in this case:
Hold the display key with its back against the
marked area on the steering column. Pay at‐
tention to the display in the instrument clus‐
2. If the display key is detected:
Switch on drive-ready state within 10 sec‐
If the display key is not detected, slightly change
the position of the display key and repeat the
Resetting the BMW display key
If the charged display key cannot be switched on
anymore or if the display does not respond to
entries anymore, the display key can be reset.
Press and hold the following buttons on the dis‐
play key at the same time for at least 10 seconds
until the display is switched off and then on
The driver's door can be locked and unlocked
without the vehicle key using the integrated key.
Depending on the national-market version, the
integrated key also fits the glove compartment.
For some country versions, unlocking from the
inside is only possible with special knowledge.
Persons who spend a lengthy time in the vehi‐
cle while being exposed to extreme tempera‐
tures are at risk of injury or death. Do not lock
the vehicle from the outside when there are
people in it.
The door lock is permanently joined with the
door. The door handle can be moved. When
pulling the door handle with the integrated key
inserted, paint or the integrated key can be
damaged. There is a risk of damage to prop‐
erty. Remove the integrated key before pulling
the outside door handle.
Press the button, arrow 1, and pull out the
integrated key, arrow 2.
Opening and closing
Online Edition for Part no. 01405A10E93 - VI/20