2008 Dodge Avenger Owner's Manual (Page 362 of 467)

2008 Dodge Avenger Owner's Manual
Posted on 19 May, 2015
Model: 2008 Dodge Avenger
Pages: 467
File size: 7 MB

Get Manual

Online Viewer
5. Connect the other cable, first to the negative terminal
of the booster battery and then to the engine ground (-)
of the vehicle with the discharged battery. Make sure
you have a good contact on the engine ground. Refer to
the following illustration for jump-starting connections.
6. If the vehicle is equipped with Sentry Key Immobi-
lizer, turn the ignition switch to the ON position for three
seconds before moving the ignition switch to the START
position.
7. Start the engine in the vehicle that has the booster
battery, let the engine idle a few minutes, and then start
the engine in the vehicle with the discharged battery.
8. When removing the jumper cables, reverse the se-
quence exactly. Be careful of the moving belts and fan.
9. Reinstall the protective cover over the remote jump-
start positive battery post.
NOTE: Refer to “Maintenance Procedures” in Section 7
of this manual for information on accessing the battery
for service or replacement.
WARNING!
Any procedure other than above could result in:
1. Personal injury caused by electrolyte squirting out
the battery vent;
2. Personal injury or property damage due to battery
explosion;
3. Damage to charging system of booster vehicle or
of immobilized vehicle.
360 WHAT TO DO IN EMERGENCIES


General
Year 2008
Make Dodge
Model Avenger
Language English
Pages 467
Filetype PDF (Download)
File size 7 MB


Table of Contents

Privacy Policy    Contact us