2011 Harley-Davidson Electra Glide Ultra Limited Owner's Manual (Page 121 of 169)

2011 Harley-Davidson Electra Glide Ultra Limited Owner's Manual
Posted on 15 Mar, 2016
Model: 2011 Harley-Davidson Electra Glide Ultra Limited
Pages: 169
File size: 4 MB

Get Manual

Online Viewer
Removal
1. Carefully pry headlamp bezel from front of motorcycle.
2. Remove four screws securing headlamp assembly to trim ring/adjuster assembly.
3. Disconnect headlamp harness from bulb and remove headlamp housing assembly.
Bulb Replacement
When replacement is required, use only the specified
sealed beam unit or bulb, available from a Harley Davidson
dealer. An improper wattage sealed beam or bulb, can
cause charging system problems. (00209a)
NOTE:
The headlamp uses a replaceable quartz halogen bulb which is bulb is very delicate and must be
handled with care.
1. See Headlamp Housing Assembly. Remove rubber boot (1).
2. Rotate retainer (2) counter clockwise and remove.
Handle bulb carefully and wear eye protection. Bulb
contains gas under pressure, which, if not handled
carefully, could cause serious eye injury. (00062b)
3. Remove and discard bulb.
Never touch the quartz bulb. Fingerprints will etch the
glass and decrease bulb life. Handle the bulb with paper or
a clean, dry cloth. Failure to do so could result in bulb
damage. (00210b)
4. See Headlamp Housing Assembly. Install new bulb in headlamp housing. Be sure tab (5)
on bulb is aligned with slot (6) in bulb housing.
5. Install retainer (2) and rotate clockwise to secure.
6. Install rubber boot (1) over retainer until flush with base of bulb socket.
7. HDI models: Rotate position lamp bulb retainer 1/4 turn counterclockwise to remove.
Replace bulb and install bulb retainer in lamp housing.
Installation
1. Install headlamp assembly and tighten screws to 15 25 in lbs (1.7 2.8 Nm).
2. Install headlamp bezel.


General
Year 2011
Make Harley-Davidson
Model Electra Glide Ultra Limited
Language English
Pages 169
Filetype PDF (Download)
File size 4 MB

Privacy Policy    Contact us