2011 Harley-Davidson Electra Glide Ultra Limited Owner's Manual (Page 21 of 169)

2011 Harley-Davidson Electra Glide Ultra Limited Owner's Manual
Posted on 15 Mar, 2016
Model: 2011 Harley-Davidson Electra Glide Ultra Limited
Pages: 169
File size: 4 MB

Get Manual

Online Viewer
Engine OFF/RUN Switch
See Basic Handlebar Controls (typical). The engine off/run switch (6) turns the ignition power
ON or OFF. The engine off/run switch is located on the right handlebar control. Push the top
portion of the engine off/run switch to turn off ignition power and shut the engine off. Push the
bottom portion of the engine off/run switch to turn on ignition power.
NOTES:
The engine off/run switch must be in the RUN position to start or operate the engine.
The engine off/run switch should be used to shut the engine off.
1. To shut the engine off, push the top of the off/run switch to the ignition OFF position.
2. See Ignition/Headlamp Key Switch. Turn the ignition key to the OFF position to turn the
ignition power completely OFF.
Throttle Control Grip
See Basic Handlebar Controls (typical). The throttle control grip (8) is located on the right
handlebar control and is operated with the right hand.
To reduce rider fatigue on long trips, a spring loaded throttle friction adjustment screw (9) is
located at the bottom of the throttle grip clamp on non cruise equipped models.
1. Slowly turn throttle control grip clockwise (toward the front of the motorcycle) to close the
throttle (decelerate).
2. Slowly turn throttle control grip counterclockwise (toward rear of motorcycle) to open the
throttle (accelerate).
Do not tighten throttle friction adjustment screw to the
point where the engine will not return to idle automatically.
Over tightening can lead to loss of vehicle control, which
could result in death or serious injury. (00031b)
3. Unscrew the throttle friction adjustment screw so the throttle returns to the idle position
when the hand is removed from the grip.
4. Screw the throttle adjustment screw in to increase friction on grip. This provides a damping
effect on throttle motion.
NOTE:
The throttle friction adjustment screw should not be used under normal stop and go operating
conditions.
Clutch Hand Lever
Do not position fingers between hand control lever and
handlebar grip. Improper hand positioning can impair
control lever operation and cause loss of vehicle control,
which could result in death or serious injury. (00032a)
See Basic Handlebar Controls (typical). The clutch hand lever (1) is located on the left
handlebar and is operated with the fingers of the left hand.


General
Year 2011
Make Harley-Davidson
Model Electra Glide Ultra Limited
Language English
Pages 169
Filetype PDF (Download)
File size 4 MB

Privacy Policy    Contact us