1. Battery
2. Battery contact
3. Circuit board
Key Fob Battery Replacement
Disabling the System
Disarm the security system using the key fob or personal code. At this point, the security fuse may
be removed or battery disconnected.
Battery Disconnects and Configuring
After reconnecting a battery, the security system will not enter the configuration mode on the first
attempt. Therefore, after all battery reconnects, the configuration sequence must be modified as
follows.
1. Set run switch to OFF, cycle ignition key ON OFF ON OFF ON and press left turn signal
switch twice.
2. Wait for one to three confirmation flashes of the turn signals and then set ignition key switch
to OFF.
3. Repeat steps listed above.
4. Continue with configuration sequence listed.
Troubleshooting the Security System
If the key fob button has been pressed numerous times while away from the vehicle, the key fob
may fall out of synchronization with the security system. If this happens, the security system might
fail to recognize the key fobs commands.