3. Lift (3) slightly to detach keyhole bracket from seat post.
4. Pull seat back (4) to detach seat tongue from fuel tank bracket.
5. Verify that tongue and mounting bracket are tightly secured to the seat bottom.
NOTE:
The passenger strap is not sold separately. Replace entire seat if the strap is damaged.
6. Two up seat: Inspect passenger strap for damage or excessive wear.
1. Remove screw
2. Press down and forward
3. Lift
4. Pull back
Remove Seat
Installation
1. See Solo and Two Up Seats. Position seat on frame with mounting bracket (1) at rear.
2. Slide seat forward until the tongue (2) fits snugly under fuel tank bracket.
3. Push seat forward to engage keyhole (3) onto seat post. Pull seat back slightly.
NOTE:
Mounting bracket of solo seat uses forward hole in rear fender. Dual seat bracket uses rearward hole.
4. Install seat mounting screw with captive washer to fasten seat mounting bracket to top of rear fender. Tighten to 15 30 in lbs (1.7 3.4 Nm).
After installing seat, pull upward on seat to be sure it is locked in position. While riding, a