7. Turn ignition/headlamp switch to IGNITION position. Set handlebar headlamp switch to
HIGH beam position.
8. Check light beam for proper height alignment:
a. Main beam of light (broad, flat pattern of light) should be centered equally above and
below horizontal line on screen or wall.
b. Main beam of light should be directed straight ahead. Properly adjusted headlamps
project an equal area of light to right and left of center.
9. Adjust headlamp alignment if necessary.
1. 25 feet (7.6 meters)
2. 35 inches (0.9 meters)
Headlamp Alignment: Sportster Models
Adjustment
1. See Headlamp Snap Plug: Sportster Models. Remove snap plug (1) on top of
headlamp bracket (2).
2. See Headlamp Clamp Nut: Sportster Models. Loosen headlamp clamp nut.
3. Tilt headlamp up or down to properly aim it in relation to the horizontal line and, at the same
time, turn it right or left to direct light beam straight ahead.
4. Tighten headlamp clamp nut to 120-240 in-lbs (14-27 Nm) after lamp is properly positioned.
Install snap plug in headlamp bracket.