2006 Harley-Davidson Street Bob (EFI) Owner's Manual (Page 54 of 126)

2006 Harley-Davidson Street Bob (EFI) Owner's Manual
Posted on 15 Mar, 2016
Model: 2006 Harley-Davidson Street Bob (EFI)
Pages: 126
File size: 2 MB

Get Manual

Online Viewer
To solve this problem, press and hold the key fob button for 10 15 seconds until the security
system responds with two turn signal flashes. After confirmation, you may resume normal key fob
operation.
Siren Diagnostics
See Siren. If the siren is armed and the internal siren battery is dead, shorted,
disconnected, or has been charging for a period longer than 24 hours, the siren will respond
with three chirps on arming instead of two.
The internal siren battery may not charge if the vehicle's battery is less than 12.5 volts.
If the siren does not chirp two or three times on a valid arming command from the security
system, the siren is either not connected, not working, or the siren wiring was opened or
shorted while the siren was disarmed.
If the siren enters the self driven mode where it is powered from the siren internal 9 volt
battery, the turn signal lamps may or may not alternately flash. If the security system
activates the siren, the turn signal lamps will alternately flash. If the siren has been armed
and a security event occurs, and the siren is in self driven mode, the siren will alarm for 20
to 30 seconds and then turn off for 5 to 10 seconds. This alarm cycle will be repeated ten
times if the siren is in the self driven mode.
Siren
Operation
Operating Recommendations: Dyna Models
Do not run the engine at extremely high RPM with clutch
disengaged or transmission in neutral. Running an engine
at high RPM can result in engine damage. (00177a)


General
Year 2006
Make Harley-Davidson
Model Street Bob (EFI)
Language English
Pages 126
Filetype PDF (Download)
File size 2 MB
2006 Harley-Davidson Street Bob (EFI) Models

Privacy Policy    Contact us