2014 Harley-Davidson Street Glide Special Owner's Manual (Page 109 of 177)

2014 Harley-Davidson Street Glide Special Owner's Manual
Posted on 15 Mar, 2016
Model: 2014 Harley-Davidson Street Glide Special
Pages: 177
File size: 4 MB

Get Manual

Online Viewer
D.O.T. 4 brake fluid will damage painted and body panel
surfaces it comes in contact with. Always use caution and
protect surfaces from spills whenever brake work is
performed. Failure to comply can result in cosmetic
damage. (00239b)
3. Clean all dirt and debris from the clutch master cylinder cover. Remove the two clutch
master cylinder cover screws. Remove the cover.
4. Verify that the fluid level in the clutch master cylinder reservoir is at the FILL LEVEL mark at
the top of the ledge on the rear inside wall of the reservoir. If the fluid level is low, add DOT
4 BRAKE FLUID which is approved for clutch system use and available from a Harley
Davidson dealer.
NOTES:
Do not overfill clutch reservoir. Clutch fluid volume increases with clutch wear. Over
filling can damage seals and damage clutch system.
If fluid level is substantially above the FILL LEVEL, a worn clutch may be the cause.
D.O.T. 4 hydraulic brake fluid is used in the hydraulic
clutch. Do not use other types of fluids as they are not
compatible and could cause equipment damage. (00353a)
Do not allow dirt or debris to enter the master cylinder
reservoir. Dirt or debris in the reservoir can cause
improper operation and equipment damage. (00205c)
Direct contact of D.O.T. 4 brake fluid with eyes can cause
irritation. Avoid eye contact. In case of eye contact flush
with large amounts of water and get medical attention.
Swallowing large amounts of D.O.T. 4 brake fluid can
cause digestive discomfort. If swallowed, obtain medical
attention. Use in well ventilated area. KEEP OUT OF
REACH OF CHILDREN. (00240a)
5. Inspect the clutch master cylinder cover gasket for rips, cuts, cracks or other signs of
damage. Replace the gasket if necessary. Carefully place the cover and cover gasket on the
master cylinder reservoir. Secure with the two cover screws. Tighten the screws to 8 10 in
lbs (0.9 1.1 Nm).
NOTE:
If the fluid level is correct but the clutch does not operate properly, refer to the service
manual or see a Harley Davidson dealer for service.


General
Year 2014
Make Harley-Davidson
Model Street Glide Special
Language English
Pages 177
Filetype PDF (Download)
File size 4 MB

Privacy Policy    Contact us