4. Install shoulder bolt and washer to secure seat and grabstrap. Tighten securely.
5. Slide pillion through grabstrap and align the slot under the pillion with the head of the
shoulder bolt.
6. Slide seat backward until firmly secured on the shoulder bolt.
7. Install screw (1) and washer (2). Tighten securely.
After installing seat, pull upward on seat to be sure it is
locked in position. While riding, a loose seat can shift
causing loss of control, which could result in death or
serious injury. (00070b)
8. Pull up on seat to verify that it is properly secured.
Removal: All Other Models
1. See Seat. Remove screw (1) and washer (2).
2. Raise seat slightly and remove nut (7), washers (5 and 6) and bolt (4). Remove grabstrap.
3. Slide seat to the rear of the motorcycle and remove.
Installation: All Other Models
1. Put seat on frame backbone.
NOTE:
There is a tab at the front of the seat that slips under the rear fuel tank mount.
2. Slide seat toward front of motorcycle until the tab locks under the fuel tank mount.
3. See Seat. Push seat forward until rear fender seat retention nut is centered in hole of
mounting bracket.
4. Install bolt (4), washers (5 and 6) and nut (7) to secure seat grabstrap. Tighten to 60 90 in lb
(6.7 10.2 Nm).
5. Install screw (1) and washer (2). Tighten securely.
After installing seat, pull upward on seat to be sure it is
locked in position. While riding, a loose seat can shift
causing loss of control, which could result in death or
serious injury. (00070b)
6. Pull up on seat to verify that it is properly secured.