Remove the wheel and side collar.
u Support the brake caliper assembly so
that it doesn’t hang from the brake
hose. Do not twist the brake hose.
u Avoid getting grease, oil, or dirt on the
disc or pad surfaces.
u Do not push the brake pedal while the
brake caliper is removed.
Before installing the wheel, check that the
wheel hub and final drive gear splines are
coated with molybdenum disulfide paste.
Recommended molybdenum disulfide
Pro Honda Moly 60 paste or equivalent
Install the side collar and position the
wheel between the swingarm and the final
drive gear case.
u Be sure the splines on the wheel hub
fit into the final drive gear case.
Install the rear brake bracket and rear
brake bracket bolt.
When installing a wheel or caliper into original
position, carefully fit the brake disc between the
pads to avoid scratching them.
Push the rear axle shaft from the left side,
through the wheel hub and rear brake
Remove the protective tape or an
Install the rear axle nut and washer.
Tighten the rear axle nut.
Torque: 94 lbf·ft (127 N·m, 13.0 kgf·m)
20170726153758_31MFR6800_enu_BOOK Page 104 Wednesday, July 26 2017 15:43:25 JST
Tire Puncture u Removing Wheels