While holding the other end of the rear
axle shaft with a wrench, remove the rear
Pull the rear axle shaft out and remove
the side collar.
Move the wheel to the right to separate it
from the final drive gear case.
Remove the wheel.
Before installing the wheel, check that the
wheel hub and final drive gear splines are
coated with molybdenum disulfide paste.
Recommended molybdenum disulfide
(USA only) Pro Honda Moly 60 Paste or
Position the wheel between the swingarm
and the final drive gear case.
Be sure the splines on the wheel hub
fit into the final drive gear case.
Install the side collar into the brake panel.
Insert the rear axle shaft from the right
side, through the right swingarm, brake
panel, wheel hub and final drive gear
20170804180835_31MJA8000_enu_BOOK Page 92 Friday, August 04 2017 18:14:25 JST
Tire Puncture u Removing Wheels