3. Using both hands, simultaneously push
and hold both the HomeLinkT button you
want to program and the hand-held trans-
mitter button.
DO NOT release the buttons until step 4
has been completed.
4. Hold down both buttons until the indica-
tor light on HomeLinkT flashes, changing
from a “slow blink” to a “rapid blink”.
This could take up to 90 seconds. When
the indicator light blinks rapidly, both
buttons may be released. The rapidly
flashing light indicates successful pro-
gramming. To activate the garage door or
other programmed device, push and hold
the programmed HomeLinkT button - re-
leasing when the device begins to acti-
vate.
5. If the indicator light on HomeLinkT blinks
rapidly for two seconds and then turns
solid, HomeLinkT has picked up a “rolling
code” garage door opener signal. You will
need to proceed with the next steps to
train HomeLinkT, completing the pro-
gramming may require a ladder and an-
other person for convenience.
6. Push and release the program button
located on the garage door opener’s mo-
tor to activate the “training mode”. This
button is usually located near the an-
tenna wire that hangs down from the
motor. If the wire originates from under a
light lens, you will need to remove the
lens to access the training button.
NOTE:
Once you have pushed and released the training
button on the garage door opener’s motor and
the “training light” is lit, you have 30 seconds in
which to perform step 7. For convenience, use
the help of a second person to assist when per-
forming this step.
7. Quickly (within 30 seconds of pushing
and releasing the garage door opener
training button) and firmly push and re-
lease the HomeLinkT button you’ve just
programmed. Push and release the
HomeLinkT button up to three times to
complete the training.
8. Your HomeLinkT button should now be
programmed. To program the remaining
HomeLinkT buttons for additional door or
gate openers, follow steps 2 through 8
only.
NOTE:
Do not repeat step 1 unless you want to “clear”
all previously programmed HomeLinkT buttons.
If you have any questions or are having diffi-
culty programming your HomeLinkT buttons,
please refer to the HomeLinkT web site at:
www.homelink.com or call 1-800-355-3515.
SIC3183
2-58 Instruments and controls
w —
—
07/14/07—pattie
X