2023 Jeep Grand Cherokee 4xe Owner's Manual (Page 123 of 372)

2023 Jeep Grand Cherokee 4xe Owner's Manual
Posted on 17 Feb, 2023
Model: 2023 Jeep Grand Cherokee 4xe
Pages: 372
File size: 26 MB

Get Manual

Online Viewer
STARTING AND OPERATING 121
SHIFTING PROCEDURES
4WD HI To 4WD LOW
With the vehicle at speeds of 0 to 3 mph (0 to 5 km/h), the
ignition switch in the ON/RUN position and the engine
running, shift the transmission into NEUTRAL (N), push
and hold the 4WD LOW button until the 4WD LOW
Indicator Light begins to flash in the instrument cluster.
When the shift is complete, the 4WD LOW Indicator Light
will remain on solid.
4WD LOW Button
NOTE:
If shift conditions/interlocks are not met, a “To Complete
4WD Shift Put Transmission In Neutral” or a To Complete
4WD Shift Speed Must Be Below 3 MPH” or a “To
Complete 4WD Shift Allow Engine To Return To Idle”
message will flash from the instrument cluster display
Ú page 88.
4WD LOW To 4WD HI
With the vehicle at speeds of 0 to 3 mph (0 to 5 km/h), the
ignition switch in the ON position or the engine running,
shift the transmission into NEUTRAL (N), push and hold
the 4WD LOW button until the 4WD LOW Indicator Light
begins to flash in the instrument cluster. When the shift is
complete, the 4WD LOW Indicator Light will remain off.
NOTE:
If shift conditions/interlocks are not met —
“4WD Shift Canceled” or “4WD Shift Aborted/ Retry
Shift” message will be displayed on the instrument
cluster. To reattempt shift, put the transmission in
NEUTRAL (N) and push and hold the 4WD LOW button.
If shift conditions/interlocks are not met, a “To
Complete 4WD Shift Put Transmission In Neutral” or a
“To Complete 4WD Shift Speed Must Be Below 3 MPH”
or a “To Complete 4WD Shift Allow Engine To Return To
Idle” message will flash from the instrument cluster
display
Ú page 88.
Shifting into or out of 4WD LOW is possible with the
vehicle completely stopped; however, difficulty may
occur due to the mating clutch teeth not being properly
aligned. Several attempts may be required for clutch
teeth alignment and shift completion to occur. The
preferred method is with the vehicle rolling 0 to 3 mph
(0 to 5 km/h). If the vehicle is moving faster than
3 mph (5 km/h), the transfer case will not allow
the shift.
QUADRA-TRAC II SYSTEM
I
F EQUIPPED
The Quadra-Trac II System features two torque transfer
couplings. The couplings include an Electronic
Limited-Slip Differential (ELSD) rear axle and the
Quadra-Trac II transfer case. The ELSD axle is fully
automatic and requires no driver input to operate. Under
normal driving conditions, the unit functions as a standard
axle, balancing torque evenly between left and right
wheels. With a traction difference between left and right
wheels, the coupling will sense a speed difference. As one
wheel begins to spin faster than the other, torque will
automatically transfer from the wheel that has less
traction, to the wheel that has traction. While the transfer
case and axle coupling differ in design, their operation is
similar. Follow the Quadra-Trac II transfer case shifting
information, preceding this section, for shifting this
system.
4
23_WL_OM_EN_USC_t.book Page 121


General
Year 2023
Make Jeep
Model Grand Cherokee 4xe
Language English
Pages 372
Filetype PDF (Download)
File size 26 MB

Privacy Policy    Contact us