MAINTENANCE AND ADJUSTMENT 71
j
A. Flywheel
B. Flywheel & Pulley Holder (Special Tool:
57001-1605)
•
Tighten the clutch spring bolts to the specified
torque.
Tightening Torq
ue
Clutch Spring Bolts:
9.3N·m(0.95kgf·m,82in·lb)
•
Re
place the clutch cover gasket with a new one.
•
Turn the clutch release lever toward the rear so
that the push rod fit into the release lever shaft.
•
Install the clutch cover to the crankcase, making
sure that the two dowel pins are installed between
mating surfaces.
•
Tighten the c lutch cover bolts to the specified
torque.
Tightening Torque
Clutch Cover Bolts:
9.4 N·m (1.0 kgf·m, 83 in·lb)
•
Check
the clutch release lever position by mea-
suring the position distance between the lever and
the cable bracket while pushing the clutch release
leve
r lightly forward.
A. Clutch Releas e Lever
B. Push forward
C. Cable Bracket
D. Position D is tance (Between Lever and Cabl e
Bracket)
Position Distance
Standard 48 58 mm (1.9 2.3 in .)