Features of your vehicle
Reprogramming a single HomeLink
To program a new device to a previously
button, follow these
1. Press and hold the desired HomeLink
button. Do NOT release until step 4
has been completed.
2. When the indicator light begins to flash
slowly (after 20 seconds), position the
handheld transmitter 1 to 3 inches
away from the HomeLink
3. Press and hold the handheld transmit-
ter button. The HomeLink
light will flash, first slowly and then rap-
4. When the indicator light begins to flash
rapidly, release both buttons.
5. Press and hold the just-trained
button and observe the red
Status Indicator LED. If the indicator
light stays on constantly, programming
is complete and your new device
Individual buttons cannot be erased.
However, to erase all three programmed
1. Press and hold the two outer
buttons until the indicator
light begins to flash-after 20 seconds.
2. Release both buttons. Do not hold for
longer than 30 seconds.
The Integrated HomeLink
Control System is now in the training
(learn) mode and can be programmed at
any time following the appropriate steps
in the Programming sections above.
FCC ID: NZLZTVHL3
This device complies with Industry
Canada standard RSS-210.
Operation is subject to the following two
1. this device may not cause harmful
2. This device must accept any interfer-
ence received, including interference
that may cause undesired operation.
is a registered trademark and Z-
Nav™ is a trademark of the Gentex
Corporation, Zeeland, Michigan.
is a registered trademark
owned by Johnson Controls,
Incorporated, Milwaukee, Wisconsin.
The transceiver has been tested
and complies with FCC and
Industry Canada rules. Changes or
modifications not expressly
approved by the party responsible
for compliance could void the
user's authority to operate the