Manual Description
Inspect drive belt deflection or tension at a point on the belt midway between pulleys. Adjust if belt deflection exceeds the limit or if belt tension is not within specifications. Remove two engine-to-transmission bolts and install them into open bolt holes shown.
Remove two oil pan-to-transmission bolts previously installed in aluminum oil pan. I Apply new engine oil to bolt threads and seat surfaces when installing, camshaft sprockets, crankshaft pulley, and camshaft brackets. I After installing, confirm that mating marks on rotor shaft of camshaft position sensor are as shown.
Apply a continuous bead of liquid gasket to mating surface of cylinder head front cover. Remove all old liquid gasket from mating surfaces of rocker cover and cylinder head. Apply a continuous bead of liquid gasket to mating surface of rocker cover gasket and cylinder head.
Manual Cover
General