Manual Description
Also check that it returns to idle position when pedal is released. I When connecting accelerator wire, be careful not to twist or scratch its inner wire. Tighten accelerator adjusting nut until throttle drum starts to SC move.
Tightening torque specifications are the same for all rubber hose clamps. After engine stalls, crank engine two or three times to make sure that fuel pressure is released. Turn ignition switch off and install fuse for fuel pump.
I After installation, run engine and check for fuel leaks at connections. I Plug hose and pipe openings to prevent entry of dust or oil. Remove inspection hole cover located behind the rear seat.
Manual Cover
General