Online Viewer
Manual Description
Cover openings of engine system with tape or the equivalent, if necessary, to seal out foreign materials. Mark and arrange disassembly parts in an organized way for easy troubleshooting and assembly. M When tightening nuts and bolts, as a basic rule, equally tighten in several different steps starting with the ones in center, then ones on inside and outside diagonally in this order.
Thoroughly clean the gasket application surface and the mating surface removing any adhering moisture, grease and foreign material. Apply the sealant without breaks to the specified location with the specified dimensions. Wait 30 minutes or more after installation before filling the C engine with oil and coolant.
Inspection should be done only when engine is cold, or over 30 minutes after engine is stopped. Then, after turning the crankshaft two turns or more, re-adjust to the specified value to G avoid variation in deflection between pulleys. Tighten idler pulley lock nut by hand and measure deflection or tension without looseness.
Manual Cover
General