Manual Description
In addition, if wheel sensor 2 is displayed for the wheels, check the wheel sensor circuit and also check the control unit power voltage. Intermittent errors may be caused by a poor connection in the harness, connector, or terminal. If a circuit tester is used for the check, be careful not to forcibly extend any connector terminal.
Use lower speeds when driving on Normal (longer stopping distance) these kinds of roads. Make sure lamp turns off approximately 1 second after the ignition switch is turned on. Do not expand the terminal of the connector with a/the tester terminal stick, when it does the inspection with the tester.
Repeat Pumping brake pedal carefully several times, then perform self-diagnosis again. When installing, check that there is no foreign material such as iron chips on pick-up and mounting hole of the sensor. When installing front sensor, be sure to press rubber grommets in until they lock at the three locations shown in diagram (2 at shock absorbers and 1 at body panel).
Manual Cover
General