Manual Description
Remove guide plate mounting bolts and then separate control lever assembly from the control lever housing. Lower a suitable jack to the position where the back-up lamp switch harness connector can be disconnect. Remove rear extension upper cover and rear extension upper cover gasket from the rear extension.
Then remove check H shift pin and control bracket as one unit from the rear extension. Remove reverse idler thrust washer, revers idler gear, and reverse idler needle bearing from the reverse idler shaft. Remove front cover mounting bolts, then remove front cover and front cover gasket from the transmission case.
Using a soft hammer to carefully tap main shaft and counter H shaft from the transmission case side, and then separate adapter plate and transmission case. Install adapter setting plate to the adapter plate and then fixing in adapter setting plate using a vise. Remove baffle plate mounting bolts, and remove baffle plate from the adapter plate.
Manual Cover
General