Manual Description
N Use a flare nut wrench when removing flare nuts, and use a flare nut crowfoot and torque wrench when tighten brake tube flare nuts. Besides electrical system inspection, check booster operation, brake fluid level, and oil leaks. Each control unit transmits/receives data but selectively reads required data only.
In this case, it will be effective to shake suspected harness or connector by hand. In addition, if wheel sensor 2 is displayed for the wheels, check the wheel sensor circuit and also check the control unit power voltage. Then use screen monitor to check that solenoid valve operates as shown in the table below.
K If a circuit tester is used for the check, be careful not to forcibly extend any connector terminal. Use lower speeds when driving on Normal (longer stopping distance) these kinds of roads. Make sure lamp turns off approximately 1 second after the ignition switch is turned on.
Manual Cover
General