Manual Description
After remove coil spring with a spring compressor (commercial service tool), and then gradually release a spring compressor. Compress coil spring using a spring compressor (commercial service tool), and install it onto shock absorber. Insert bound bumper into shock absorber mounting bracket, and then install it to shock absorber together with rubber seat.
Secure piston rod tip so that piston rod does not turn, then tighten piston rod lock nut with specified P torque. Gradually release a spring compressor (commercial service tool), and remove coil spring. Position the drilled hole downward and drain oil by moving the piston rod several times.
M Never tap on the ball joint cap of the stabilizer connecting rod with a hammer or a similar item when inserting the stabilizer connecting rod into the transverse link. Confirm spring balance measurement value is within specifications when ball stud begins moving. L Perform final tightening of bolts and nuts at the vehicle installation position (rubber bushing), under unladen conditions with tires on level ground.
Manual Cover
General