Manual Description
Also, this will permit the service part to be accurately cut at the joint position. When repairing and painting a portion of the body adjacent to plastic parts, consider their characteristics (influence of heat and solvent) and remove them if necessary or take suitable measures to protect them. Plastic parts should be repaired and painted using methods suiting the materials, characteristics.
Insert nozzle into hole near fill area and fill foam material or fill enough to close gap with the service part. Therefore, when such a panel is replaced or repaired, apply undercoating to that part. Never apply undercoating to any place unless specified (such as the areas above the muffler and three way catalyst that are subjected to heat).
Sealant that is applied to these areas should be smooth and free from cuts or gaps. Care should be taken not to apply an excess amount of sealant and not to allow other unaffected parts to come into contact with the sealant. A wheel arch is to be installed and hemmed over the left and right outer wheel houses.
Manual Cover
General