Manual Description
Check that the fluid level in the reservoir tank is within the specified range after air bleeding. Then depress the brake pedal several times at 5-second intervals until the accumulated vacuum is released to atmospheric pressure. Check that the clearance between brake pedal and dash lower panel gradually increases each time the brake pedal is depressed when performing this operation.
Check that the brake pedal stroke does not change after holding down the brake pedal for 30 seconds or more. Depress brake pedal with the power to stop vehicle within 3 to 5 seconds until the vehicle stops. Fix the disc rotor to the wheel hub and bearing assembly with wheel nuts (2 points at least).
Refinish the disc rotor if the runout is outside the limit even after performing the above operation. Loosen the flare nut with a flare nut wrench and separate the brake tube from the hose, and remove the brake tube. Remove the union bolt and copper washers, and remove the brake hose from the brake caliper assembly.
Manual Cover
General