Manual Description
Put matching marks on slide joint housing and inner race, before separating joint assembly. Before separating joint assembly, put matching marks on drive shaft and joint assembly. Support bearing Make sure wheel bearing rolls freely and is free from noise, cracks, pitting or wear.
Make sure joint assembly matching marks which were made during disassembly are properly aligned. Install new snap ring ''B'', then securely install ball cage, inner race and balls as a unit, making sure the marks which were made during disassembly are properly aligned. Replace transverse link assembly if any of the following cases occur: Ball stud is worn.
Before checking, turn ball joint at least 10 revolutions so that ball joint is properly broken in. Spare tire, jack, hand Boot length mm (in) tools and mats in designated positions.
Manual Cover
General