Manual Description
When replacing wheel bearing, replace complete wheel bearing assembly (inner races and outer race). Do not apply oil or grease to mating surfaces of wheel G bearing outer race and knuckle. Loosen the lower ball joint tightening nut and separate the lower ball joint front transverse link using Tool.
Remove support bearing bolts using power tool, and pull drive shaft from transaxle. Push drive shaft, then press-fit circular clip on the drive shaft into circular clip groove of side gear. Tighten lower ball joint tightening nut and connecting rod nut, wheel bearing lock nut.
Put matching marks on slide joint housing and inner race, before separating joint assembly. Put matching marks on slide joint housing and drive shaft before separating joint assembly. Before separating joint assembly, put matching marks on drive shaft and joint assembly.
Manual Cover
General