Manual Description
Turn the four retainers 90° in a clockwise direction and remove the fuel pump inspection hole cover. If the connector and the tube are stuck together, push and pull M several times until they start to move. Only when the tube is replaced, remove the remaining retainer on the tube or fuel level sensor, fuel filter, and fuel pump assembly.
When the tube or fuel level sensor, fuel filter, and fuel pump assembly is replaced, also replace the retainer with a new one (green colored retainer). Start the engine and let it idle and check for fuel leaks at the fuel system connections. If the fuel M gauge indicates more than the level as shown (7/8 full), drain the fuel from the fuel tank until the fuel gauge indicates a level at or below as shown (7/8 full).
Insert fuel tubing into the fuel tank through the fuel filler hose to drain fuel from the fuel tank. Disconnect the quick connectors as follows: Hold the sides of the connector, push in tabs and pull out the tube. If the connector and the tube are stuck together, push and pull several times until they start to move.
Manual Cover
General