Manual Description
Remove the lower ball joint pinch bolt using power tool, then separate lower ball joint from steering H knuckle. Remove drive shaft from wheel hub and bearing assembly, using a puller or suitable tool. Remove the lower ball joint pinch bolt using power tool, then separate lower ball joint from steering knuckle.
Remove support bearing bolts using power tool, and pry drive H shaft from transaxle. L If damaged, disassemble drive shaft to verify damage, and repair or replace as necessary. Put matching marks on slide joint housing and shaft before separating joint assembly.
Install spider assembly securely, making sure the matching marks which were made during disassembly are properly aligned. After installation, pull shaft to check engagement between slide joint assembly and stopper ring. If boot position is not correct, remove old boot bands then reposition the boot and secure with new boot bands.
Manual Cover
General