Manual Description
Install 3rd-4th fork rod (2) and then install retaining pin to 3rd-4th shift fork (1). Then rotate reverse fork rod to a position where bracket of reverse fork rod does not interfere with striking lever of striking rod assembly. Install selected differential side bearing adjusting shim(s) and differential side bearing outer race.
Install selected reverse idler gear adjusting shim onto reverse idler gear assembly. With shifter lever A (1) held in the position shown, temporarily assemble transaxle case to clutch housing. If snap ring is not seated in the groove on mainshaft rear bearing, remove transaxle case and repeat the procedure from step d.
Install selector lever to transaxle case and then install retaining pin to selector lever. Install guide bolt to transaxle case and then tighten guide bolt to H the specified torque. Using a depth micrometer and straightedge, measure dimension (L1) between transaxle case end face and mounting face of adjusting shim.
Manual Cover
General