Manual Description
Push out and remove the journal bearing by lightly tapping the yoke with a hammer, taking care not to damage the journal or yoke hole. Select snap rings that will provide the specified play in an axial direction of the journal, and install them. Adjust the thrust clearance between the bearing and snap ring to zero by tapping the yoke.
Make sure that the journal moves smoothly and is below the H joint flex effort specification. Measure the run out of the propeller shaft tube at several points by rotating the final drive companion flange with your hands. Put matching marks on the rear propeller shaft flange yoke and the companion flange of the rear final drive as shown.
Select snap rings that will provide the specified play in an axial E direction of the journal, and install them. Make sure that the journal moves smoothly and is below the joint flex effort specification.
Manual Cover
General