Manual Description
When the windshield washer fluid level is low, the washer level switch provides a ground signal to the combination meter (unified meter control unit). In order for the compass to operate properly (accurately) in a particular zone, the zone variation must be calibrated using the following procedure. Press the mode (N) switch repeatedly until the desired zone number appears in the display.
Once the desired zone number is displayed, stop pressing the mode (N) switch and the display will show a compass direction after a few seconds. Check voltage between combination meter harness connector M24 terminals 1, 8, 24 and ground. Check continuity between fuel level sensor unit and fuel pump harness connector (A) and ground.
Compass does not show all the directions, bridges, subways, concentrations of H one or more is missing. This system includes seat belt switch inputs and dual stage front air bag modules. Remove the combination meter upper screws (A) using power tool, and pull out the combination meter (1).
Manual Cover
General