Manual Description
Loosen the bleeder valve and bleed air with the brake pedal depressed, and then quickly tighten the bleeder valve. Perform steps 1 to 5 for the rear right brake → front left brake → rear left brake → and front right brake in order. Check that the fluid level in the reservoir tank is within the specified range after air bleeding.
Run the engine for 1 minute to apply vacuum to the brake booster, and stop the engine. Then depress the brake pedal several times at 5-second intervals until the accumulated vacuum is released to atmospheric D pressure. Check that the clearance between brake pedal and dash lower panel gradually increases each time the brake pedal is depressed when performing this operation.
Depress brake pedal with the power to stop vehicle within 3 to 5 seconds until the vehicle stops. Fix the disc rotor to the wheel hub and bearing assembly with wheel nuts (2 points at least). Refinish the disc rotor if the runout is outside the limit even after performing the above operation.
Manual Cover
General