Manual Description
Remove drain plug (1) and gasket, using a socket [Commercial service tool] and then drain gear oil. Set a gasket on drain plug and install it to clutch housing, using a socket [Commercial service tool]. Fill with new gear oil until oil level reaches the specified limit at filler plug mounting hole as shown in the figure.
Remove differential side oil seals (1) from clutch housing and transaxle case, using a suitable tool. Pull out and disconnect the each cable from the shifter lever A and the selector lever, using a suitable remover. Remove each lock plate upward to disconnect the each cable from the cable mounting bracket.
Do not perform tapping by other than screwing tapping bolts because tapping is formed by screwing tapping bolts into transaxle case. Never confuse the lock plate with the lock plate (3) which fixes the shifter cable (4). Install the selector cable (1) on the cable mounting bracket to O install the lock plate.
Manual Cover
General