Manual Description
If a new torsion bar spring or anchor arm is installed, adjust anchor arm length to the dimension indicated in the figure at the left. Tighten the adjusting nut so the torsion bar length corresponds with dimension L” previously measured during torsion bar removal. If a new torsion bar spring or anchor arm is installed, tighten the adjusting nut to the dimension indicated in the figure at the left, then tighten the lock nut to specifications.
Bounce vehicle with tires on ground (Unladen) to eliminate friction of suspension. Exercise the front suspension by bouncing the front of the vehicle 4 or 5 times to ensure that the vehicle is in a neutral height attitude. While aligning the adjusting bolts with the matching marks, install the upper link.
If a new upper link or any other suspension part is installed, align the matching mark with the slit as indicated in the figure at the left, then install the upper link. Press bushing so that the flange of bushing securely contacts the end surface of the upper link collar. If ball is worn and play in axial direction is excessive or joint is hard to swing, replace as a upper link or lower link.
Manual Cover
General