Manual Description
Rev engine two or three times under no-load, then run engine at idle speed for about 1 minute. Start engine and rev it (2,000 to 3,000 rpm) two or three times under no-load, then run engine at idle speed. Turn off engine and connect throttle position sensor harness connector to throttle position sensor.
Rev engine (2,000 to 3,000 rpm) two or three times under no-load, then run engine at idle speed. Then connect harness connector terminal for heated oxygen sensor 1 to ground with a jumper wire. Start engine and warm it up until engine coolant temperature indicator points to middle of gauge.
Maintain engine at 2,000 rpm under no-load (engine is warmed up to normal operating temperature. Stop engine and disconnect fuel pressure regulator vacuum hose from intake manifold. These items are required by legal regulations to continuously monitor the system/ component.
Manual Cover
General