Manual Description
Do not tighten hose clamps excessively to avoid damaging hoses. Tighten high pressure rubber hose clamp so that clamp end is 3 mm (0. Tightening torque specifications are the same for all rubber hose clamps.
After installing tubes, make sure there is no fuel leakage at connections in the following steps. Be sure to furnish the workshop with a CO2 fire extinguisher. Remove quick connectors with commercial service tool.
Do not kink or twist hoses and tubes when installed. Put mating marks on the connectors for correct installation. Hold the sides of the connector, push in tabs, and pull out the tube inserted in the retainer.
Manual Cover
General