Manual Description
If runout still exceeds specifications, replace propeller shaft assembly. If center bearing is noisy or damaged, replace center bearing. Put match marks on flanges and separate propeller shaft from final drive.
Insert plug into rear oil seal after removing rear propeller A shaft. If runout exceeds specifications, replace propeller shaft assembly. Put match marks on flanges, and separate 2nd tube from 1st tube.
Remove pushed out journal bearing by lightly tapping yoke with A a hammer, taking care not to damage journal and yoke hole. When installing center bearing, position the F” mark on center bearing toward front of vehicle. I Apply a coat of multi-purpose lithium grease containing molybdenum disulfide to the end face of the center bearing and both sides of the washer.
Manual Cover
General