Manual Description
Be sure there is no additional load in vehicle other than the driver (or equivalent weight placed in driver's I position). Adjust beam pattern until cut-off line (top edge of illumination area) is positioned at same height off ground as bulb center (on H-line). Basic illuminating area for adjustment should be within the range shown on the aiming chart.
Daytime light lamps are not turned on if engine is activated with parking brake on. The high beam headlamps are now wired in series and illuminate at a reduced intensity. Check voltage between parking brake switch harness connector B84 terminal 1 and ground.
Check voltage between daytime light relay 1 harness connector E103 terminals 2, 5 and ground. Under this condition, the headlamps remain illuminated for 5 minutes, then the headlamps are turned off. Parking lamps and headlamp will not go out when outside of the vehicle becomes light.
Manual Cover
General