Manual Description
Loosen nuts and bolts in reverse order as shown, and remove intake manifold, fuel tube protector and gasket. With engine speed increased, make sure again there are no fuel leaks at connections. Disconnect harness connector of air fuel ratio sensor 1, and harness from bracket and middle clamp.
Remove bracket between exhaust manifold–three way catalyst assembly and transmission assembly. Use scraper to remove all traces of liquid gasket from cylinder head and camshaft bracket (No. I Do not bend or twist connection between quick connector and fuel feed hose during removal and installation.
Loosen bolts in reverse order as shown and remove fuel tube and fuel injector assembly. If O-ring was stretched while it was being attached, allow it to retract before inserting it into fuel tube. D Make sure that fuel tube flange is securely fixed in flange fixing groove on clip.
Manual Cover
General