Manual Description
When runout exceeds limit value, displace mounting positions of disc rotor by one hole. If runout is outside the specified value after performing the above operation, turn disc rotor using Tool. Then with brake pedal fully depressed, start engine and when vacuum pressure reaches the standard, make sure that clearance between brake pedal and floor panel decreases.
Make sure that distance at intervals of 5 seconds between brake pedal and floor panel gradually increases. Loosen lock nut (A) on the input rod, then turn input rod to adjust the brake pedal to specified height. This might damage the paint, so when splashing it, immediately wipe off the area and wash away with water.
Make sure there is no foreign material in reservoir tank, and refill with new brake fluid. Repeat the process a few times, then pause to add new brake fluid to master cylinder. With brake pedal depressed, loosen bleed valve to let the air out, and then tighten it immediately.
Manual Cover
General