Manual Description
Make sure that distance at intervals of 5 seconds between brake pedal and floor panel G gradually increases. Loosen lock nut (A) on the input rod, then turn input rod to adjust the brake pedal to specified height. Make sure there is no foreign material in reservoir tank, and refill with new brake fluid.
Repeat the process a few times, then pause to add new brake fluid to master cylinder. This might damage the paint, so A when splashing it, immediately wipe off the area and wash away with water. With brake pedal depressed, loosen bleed valve to let the air out, and then tighten it immediately.
There should be no binding or sticking when applying or releasing the brake pedal. Install brake hose by aligning with the protrusion on caliper assembly, then install new copper sealing washers (1) and union bolt (A). Install brake tube to brake hose, then tighten flare nut to the specified torque using a suitable tool.
Manual Cover
General