Manual Description
This system includes seat belt switch inputs and dual stage front air bag modules. Heavy vibration could activate the sensor(s) and deploy the air bag(s), possibly causing serious injury. Failure to do so may result in damage to the sensor wires and the sensor becoming inoperative.
Without disassembling the hydraulic lines, remove the brake caliper using power tool. Put alignment marks on the disc rotor and wheel hub and bearing assembly, then remove the disc rotor. Apply a constant pressure on the slide hammer while turning the slide hammer 180° degrees periodically while pulling the axle oil seal out.
Remove the axle bearing studs to release the axle bearing from the back plate and torque member using a suitable hammer or press. Install the wheel studs through the grease catcher into the axle shaft using a suitable press. Install the axle bearing studs using a suitable press to attach the axle bearing to the back plate and torque member.
Manual Cover
General