Manual Description
Occasionally, it should be applied outside the holes. If engine is already started, stop it and allow 10 minutes before checking. Insert oil level gauge and check that the engine oil level is within the range (A) shown in the figure.
H If engine oil becomes turbid and white, it is highly probable that it is contaminated with engine coolant. Disconnect harness connector at oil pressure sensor (1), and remove oil pressure sensor using a deep socket (commercial service tool). Start engine and warm it up to normal operating temperature.
Check oil pressure with engine running under no-load. If difference is extreme, check oil passage and oil pump for oil leakage. After the inspections, install oil pressure sensor as follows: a.
Manual Cover
General