Manual Description
Shift the shifter lever to each gear position to check that there are no bindings. Set a suitable jack to transaxle assembly and then set a suitable jack to engine assembly. Do not perform tapping by other than screwing tapping bolts because tapping is formed by screwing tapping bolts into transaxle case.
Differential side bearing inner race (transaxle case side) (transaxle case side) 4. Differential side bearing outer race (clutch housing side) : Replace the parts as a set. Remove drain plug and gasket from clutch housing, using a socket [Commercial service tool] and then drain gear oil.
Remove selector lever (1) retaining pin with a pin punch to remove selector lever. Shift 1st-2nd fork rod (1), fork rod (2), and reverse fork rod (3) to O the neutral position. Pull up input shaft assembly (2), mainshaft assembly (3), fork rod (4), and 1st-2nd fork rod (5).
Manual Cover
General