Manual Description
Select the outer balance weight with a value closest to the calculated value above and install to the designated outer position of, or at the designated angle in relation to the road wheel. Indicated unbalance value × 5/3 = balance weight to be installed Calculation example: 23 g (0. Install drive-in balance weight on inner side of road wheel in the tire balance machine indication position (angle).
Check that the inner and outer residual unbalance value is within the M allowable unbalance value. Therefore, it is necessary to check tire air pressure frequently and replace tire with a new one, if the air pressure is decreasing. Remove valve nut retaining tire pressure sensor and allow tire pressure sensor to fall into tire.
Set tire onto the tire changer turntable so that the tire pressure O sensor inside the tire is located close to the road wheel valve hole. Turn tire so that valve hole is at bottom and bounce so that tire pressure sensor (1) is near valve hole. Carefully lift tire onto turntable and position valve hole (and tire pressure sensor) 270 degree from mounting/dismounting head (2).
Manual Cover
General