Manual Description
Do not tighten hose clamps excessively to avoid damaging hoses. Tighten high-pressure rubber hose clamp so that clamp K end is 3 mm (0. Tightening torque specifications are the same for all rubber hose clamps.
Ensure that the connector and resin tube do not contact any adjacent parts. Then check for fuel leaks at the fuel tube connections. After installing tubes, run engine and check for fuel leaks at connections.
Unscrew the fuel filler cap to release the pressure inside the fuel tank. Reposition the rear floor carpet out of the way to remove the fuel pump inspection hole cover. Turn the four retainers 90° in a clockwise direction and remove the fuel pump inspection hole cover.
Manual Cover
General