Manual Description
Check oil level, and drain and refill transaxle oil with the vehicle on level ground. B During removal or installation, keep inside of transaxle clean of dust and dirt. If mating marks are required, be certain they do not interfere with the function of the parts they are applied to.
Assemble a new o-ring on to the speedometer pinion gear, then install it in transaxle case. Measure oil level using suitable gauge as shown, and check if "L" is within the specifications. Insert the air breather hose into the transaxle tube until the overlap area reaches the spool.
Remove the clutch operating cylinder from the transaxle case and position aside without disconnecting the hydraulic lines. Remove the bolt and heated oxygen sensor harness clamp, then remove the crankshaft position sensor. Install the engine slingers on the front of the left bank cylinder, and the rear of the right bank cylinder head as shown.
Manual Cover
General