Manual Description
Drive vehicle and maintain the following conditions for at least 2 consecutive seconds. Start engine and maintain the following conditions for at least 5 consecutive seconds. Start engine and maintain the following conditions for at least 12 consecutive seconds.
Check voltage between output speed sensor (secondary speed sensor) vehicle side harness connector terminals. Check voltage between output speed sensor (secondary speed sensor) vehicle side harness connector terminal and ground. Start engine and maintain the following conditions for at least 10 consecutive seconds.
Then it changes the operating pressure of the primary pulley and the secondary pulley and changes the groove width of the pulley. Start engine and maintain the following conditions for at least 30 consecutive seconds. This B is not only caused by electrical malfunctions (circuits open or shorted), but also by mechanical malfunctions such as control valve sticking, improper solenoid valve operation, etc.
Manual Cover
General